Synchronous Motor Driven
When energized a Program Timer repeats continuously and synchronously, a pre-established sequencing of ON/OFF switching events. Also known as Cam or Multi-cam Timer, Flasher ( if single pole), Cycle or Re-cycle Timer, or Repeat Cycle Timer. One "cycle" is one revolution of the output cam shaft. These may be wired for single revolution and stop operation. An external momentary pushbutton wired as shown on Homing will cause the camshaft to rotate 1 revolution only and come to an abrupt halt. During this cycle the cams perform the prescribed sequence of operations. This popular wiring is typified in cup dispensing coffee vending machinery.
- All switches are UL and CSA approved
- UL rated 21 amperes nominal at 0.250 power factor.
- Enclosed, snap-action, sub-basic size.
- Form C - SPDT.
- 1 hp at 125 VAC, 2 hp at 250 VAC
|No# of Poles (N)||2
|Switch Type (SW)||H2
|Cycle Time (T)||
|Voltage (AC)||24 V
|Frequency1||50 - 60 Hz
|Power||1 hp at 125 VAC, 2 hp at 250 VAC
|Terminal||0.250 Male Push-ON
- Permanent magnet synchronous inductor type.
- USA industrial standard pear-shaped configuration.
- UL and CSA approved.
- Enclosed construction.
- Rated 3 watts @ 120/60 VAC.
- Torque rating 30 inch-ounces at 1 RPM.
- Stocked and standard at 120/60.
- Also readily available or stocked for 24/60, 230/60, 24/50, 115/50, and 220/50.
- These motors operate at a speed precisely synchronous with frequency of input power.
- Special motors available on request, such as reversible, variable speed, extra fast, slow, hi-torque, direct current, etc.
- Corrosion resistant.
- Tough, reliable, long-lived
- Reasonable life expectancy exceeding 10,000 hours.
- Fast acceleration. Instant stop.
- Our staff filters all incoming orders to ensure adequate motor torque.
The life of a switch is a function of the type, magnitude, and number of usages under an applied electrical load. At low electrical load 95% survival is expected at 10,000,000 operations, at full electrical load 95% survival is expected at 150,000 operations, subject to inrush considerations and type of load as to resistive, inductive, or capacitive. Particular attention should be given for high inrush applications such as heaters or lamps as might weld erode, or cavitate switch contacts. We will gladly assist customers in making a selection.
- Molded nylon with approx. 180° cuts, 7/8" diameter.
- Color coded black and white.
- Standard 7/8" diameter or jumbo 1 1/2" diameter.
- multiple machined cuts - on special order.